biOrb LED Light Instructions

LED QUICK START GUIDE

The Standard LED Light Cycle starts automatically when the light is turned on. The easiest way to ensure your light starts when you want is to plug it in at that time. For example if you want the sunrise to start at 8am, just plug the light in at that time and the sunrise will start at 8am every day from then onwards
     

STEP ONE
Plug the din socket into a Reef One 12v AC power supply (only use Reef One Power supplies). The moonlight (blue LED) will come on and the light will be in standard mode.

STEP TWO
The moonlight will then stay on as the light begins to rise up to daylight (white LED’s) simulating natural sunrise.

STEP THREE
After 1 hour, daylight will be at full power with no moonlight. In this mode, daylight will stay on for a further 8 hours

STEP FOUR
After 9 hours, the daylight will then start to fade into moonlight, stimulating a natural sunset. This will take a further 1 hour.

STEP FIVE
After 10 hours the moonlight will then remain on until the cycle repeats, this happens automatically, every 24 hours unless interrupted by power failure or user input.
   

Clean the lens and light regularly with Reef One cleaning clothes, if scale builds up use the Reef One Plastic Scratch Remover and Polish.

The LED comes with a choice of cycles which allows you to change the day and night cycle. 

Rate this FAQ

This answer was helpful

This answer was not helpful